R3.pm - Perl interface to SAP R/3 using RFCSDK COPYRIGHT ========= Copyright (c) 1999, Johan Schoen. All rights reserved. The perl modules R3.pm, R3::rfcapi, R3::conn, R3::func and R3::itab are free software; you may use, modify and redistribute them under the same terms as Perl itself. To use the R3::* modules you also need the RFCSDK which is proprietary software owned by SAP AG. INTRODUCTION ============ R3::conn, R3::func and R3::itab provide a oriented interface to SAP R/3 remote function calls. The modules needs R3::rfcapi which provides a Perl interface to RFCSDK. REQUIREMENTS ============ The R3::* modules requires Perl 5, a C compiler and SAP's RFCSDK. The RFCSDK is available on the R/3 Frontend CD and/or via ftp from any of SAP's sapserv. If you have legal access to an R/3 system you should be able to obtain it - if not, you should not use the R3::* modules anyway. INSTALLATION ============ R3.pm installation also installs R3::conn, R3::func and R3::itab. R3::rfcapi must be installed before R3.pm. Version 0.31 of R3.pm requires R3::rfcapi 0.31 or later. To install R3.pm on Linux and other UNIX like systems: $ perl Makefile.PL $ make $ make test $ make install You probably need to execute the last command as root. On NT with VC++: D:\R3>perl Makefile.PL D:\R3>nmake D:\R3>nmake test D:\R3>nmake install AUTHOR ====== R3.pm, R3::rfcapi, R3::conn, R3::func and R3::rfcapi are written by Johan Schoen, johan.schon@capgemini.se. TRADEMARK INFORMATION ===================== SAP and R/3 are trademarks of SAP AG.